Mazda CX-3 Fixings Trim Clips and Fasteners -Mk1 (2016 on)

This is probably the most common Mazda clip we sell. These are fitted to almost all modern Mazda cars produced since 2010. The clips fit into an 8m...

These small, black 6mm clips have a wide collar and are common on interior trims and panels. They are often used on boot linings, upholstery, roof ...

These interior door card clips are used on a wide range of Mazda cars to hold the interior door cards in place. Our clips include the foam sealing ...

These chunky and strong clips and used on the sills of several different Mazda models. The clips are used to fasten the side skirts or plastic sill...

Common on several Mazda models, these clips are normally used on bumpers undertrays, sill mouldings or other large panels and shields.

This interior trim panel clip is widely used by Mazda. The clips are normally used on door cards but will also be found on boot linings, pillar tri...

These green plastic moulding clips come with foam sealing washers. They are an identical and high quality alternative to the genuine Mazda part num...

These yellow weatherstrip clips are fitted to most Mazda cars since 2000. The small clips fit inside the rubber seals that run around the doors, bo...

These fir tree clips are used to secure the under bonnet sound proofing insulation on most Mazda cars since around 2003. The clips fit in a 5.5mm h...

Very common across the Mazda range, this clip is used to fasten and secure a wide variety of parts. Uses include Mazda MX-5 sideskirt clips, CX-3 b...

This part is normally used on interior panels that sit flush against the dashboard or centre console. These trims are sometimes decorative or are u...

These grey screw edge grommets or spire clips are used to join parts without necessitating damage to the metal bodywork. This part slides over the ...

Each of these fasteners includes a foam sealing washer. Example uses include Mazda CX-3 and CX-5 wheel arch flare and side moulding clips. The clip...

Grey plastic fasteners used by Mazda to attach the plastic trim that runs around the edge of the wheel arch. This clip is used on the Mazda CX-3 Mk...

Grey plastic trim clips with a foam sealing washer. The plastic fasteners are used on several Mazda models. They are in different places depending ...

These long grey expanding push fit clips are unusual in that they only expand at the very tip. They are used by Mazda on front bumpers and some doo...

These green plastic clips look different before they are fitted as they have a washer that forms part of the mould. During installation, the washer...