Audi Car Trim Clips, Fixings & Fasteners

These star or Torx head screws are a suitable replacement for the parts used on many Audi cars to secure the front and rear wheel arch linings or s...

A standard push fit plastic rivet which fits into a 7.5mm hole. The wide 22mm collar means the part is suitable for many different uses. It is used...

These simple plastic rivet clips are used on several different Audi models and across the Volkswagen range. They fit into an 8mm hole and are used ...

Audi use this clip to attach a range of different parts on several of their models. The clip can be found on exterior trims such as wheel arch lini...

These speed nuts or spire clips are used on quite a wide number of modern Audi cars to attach underbody shields and panels. If any of the panels ar...

These are very common on modern Audi cars for underbody shields, covers and splashguards. The nuts are threaded and fit onto studs already attached...

There are two very similar clips used by Audi on most of their models. This version is 22mm long and there is also a 16mm version (Our part number ...

There are two very similar clips used by Audi, Seat, Skoda and VW on most of their models. This version is 16mm long and there is also a 22mm versi...

These M5 screws are common across the Audi range and often used on wheel arch linings or for interior trim panels.

These are one of several types and sizes of screw grommet fitted to most modern Audi cars. They are used for mounting anything from number plates t...

Very common across the modern Audi range, these distinctive clips actually push in to expand and clip into place. The short stem fits into an 8mm h...

These blue clips are normally used on exterior trims such as wheel arch trims or body side mouldings. These parts are aftermarket fasteners produce...

These are large door card clips fitted to a few Audi models. The clips are distinctive and each one has an integrated rubber seal.

These clips fit into a retainer on the trim or door card. When the trim is then located and pushed onto the bodywork, these clips lock in place and...

These are used on a lot of Audi models. The parts are normally used as Audi undertray clips for attaching protective panels on the underside of the...

A common screw grommet fitted to many Audi vehicles. The clip is used throughout and example uses are wheel arch linings, pillar trims, door cards,...

These small plastic fasteners are used on the inner wing lining on a large number of Audi vehicles. The clip is used in conjunction with a metal T-...

These metal fasteners are used on the undertray and other underbody access shields to secure the panels in place. They lock and are released with a...

These distinctive green and white plastic trim clips are used on Audi models such as the Q5 and Q7. The clips are fitted to the underside of trim p...

Metal speed nut used for securing plastic arch linings and underbody trim in position.

These locking star washers are suitable for attaching underbody noise and heat insulation. The corrosion resistant parts are used throughout the Au...

These are common on vehicles produced by Audi. The clip is normally used to hold plastic trims in position in locations such as dashboards, door ca...

These small white plastic trim clips are used to secure parts such as the lower door mouldings, sill scuff plates, wheel arch flares and side body ...

These black, folding plastic clips are used around the edges of the wing and wheel arch lining on many different Audi cars. The clips are quite unu...

These locking star washers are suitable for attaching underbody noise and heat insulation. The corrosion resistant parts are used throughout the Au...

These plastic pins are used to attach the rear tow eye covers on a number of Audi and Volkswagen models. The clip twists in to lock or unlock the a...

These rubber inserts are used with other fasteners and provide a seal and firm hold into the bodywork. This part is widely used across the Volkswag...

These distinctive clips are used on modern Audi vehicles for sill mouldings and side skirts. The clip is an expanding plastic rivet with an allen k...

These are very widely used across the VAG group. The grommet is used on a large number of parts including around bumpers, sills, side skirts, wheel...

These small white plastic grommets come with integrated rubber seals. They are very commonly used on Audi cars. They are used in a wide range of pl...

These clips mount onto the bodywork or trim and allow a twist lock bolt to be secured. These are often used on removable access panels such as unde...

This plastic clip twists 90 degrees to lock in place. It is used on the underbody shields and engine undertrays on at least 3 different Audi models...

This plastic fastener fits into an 8mm diameter hole and expands to securely lock in place when the centre pin is inserted. They are used by Audi o...

These clips are used across the Audi range for everything from mounting sensors to underbody shields and interior carpets and upholstery. All of ou...

These small plastic weather strip clips are used to secure the rubber seals around the door openings. The canoe shaped head of the clip fits inside...

These metal spring fasteners are used to attach fascias and trim panels to items such as door cards, dashboards and seat backs. These parts are hig...

Very common across the entire Volkswagen Group of VW, Audi, SEAT, Skoda and Porsche. The clips are used with wheel arch liners, interior trims, qua...

A simple plastic trim clip that expands when the centre pin is inserted. This type of clip is used on many vehicle and has lots of different uses. ...

These clips are used to lock twist lock bolts in place. This is the retainer that the key of the bolt pushes into and then turns to lock in place. ...

This is a very common and very widely used clip. It's normally used on interior trims but can be for a very wide range of purposes. Door cards, pil...

This sprung clip is very simple. The clip squeezes together to be fitted and expands once it is in place. Most Audi vehicles use these to fasten bo...

This plastic washer is used with twist lock bolts and act to hold the removable covers in place onto rear bumpers of several Audi cars. The covers ...

These clips are normally used on or around the front bumpers and wheel arches. The clip is sometimes used with a screw through the middle to connec...

These metal springs are used to attach interior parts such as the interior pillar covers and door entrance sill trims.

A popular 8mm push pin rivet that is used on some Audi cars to attach splashguards, bumper covers and engine bay covers.

A simple push fit expanding plastic fastener which is only unusual due to the large head on the push pin. These types of clip are normally used on ...

These single use 7mm black fir tree clips are used by Audi on several different models. The clips are black with a 20mm diameter head. They are use...